Your water heater is one rather used and costly appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating and energy costs.
Regular flushing of your water heater is considered the single most important step you consider to prolong its service life in addition, it save energy. For time, sediments build up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most associated with the country, the typical water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is vital in today’s economic condition. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month.
To drain your water heater, you can find should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located on a water inlet line going into your water heater. Then you’re connect a hose to the drain valve located towards the bottom of the central heater. Open the drain and allow it working out until all from the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until the water flows out perfectly. This will allow air to vent from the heater and the hot water lines. Finally, you can turn the thermostat back to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your residence to filter or condition the water so may be less corrosive to your plumbing system, particularly in areas possess hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in place to discuss options and merchandise to work for you.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX